Specifications

8
Need help or have any questions? Call us at 1-714-963-0329 or send us an email to [e-mail]
❑ Kwik Bond 5 Minute Epoxy
❑ # 1 Phillips Head Screwdriver
❑ Excel Modeling Knife
❑ Electric or Hand Drill
❑ 5/64", 7/64" and1/8" Drill Bits
❑ Ruler
❑ Pencil
YOU'LL NEED THE FOLLOWING PARTS:
❑ (1) Fiberglass Fuselage
❑ (1) Left & Right Wing Panels
❑ (1) Center Section Reinforcement Board
❑ (1) Trailing Edge Reinforcement Board
❑ (1) Fiberglass Belly Pan
❑ (1) 3mm Plywood Plate w/Tab
❑ (1) 3mm Plywood Plate - Rounded w/Notch
SECTION 6: WING ASSEMBLY & MOUNTING
❑ (1) 3mm Plywood Plate - Rounded w/Cutout
❑ (3) 3mm x 15mmm x 20mm Plywood Plates
❑ (2) 180mm Balsa Support Rails
❑ (1) 30mm Fiberglass Dowel
❑ (1) 3mm x 18mm Wood Screw
❑ (2) Prebent Aileron Torque Rods
❑ (1) Aileron Reinforcement Board - 2 Parts
YOU'LL NEED THE FOLLOWING TOOLS AND SUPPLIES:
❑ 220 Grit Sandpaper w/Sanding Block
❑ Rotary Tool w/Cutting Wheel & Sanding Drum
❑ Masking Tape
❑ Paper Towels
❑ Rubbing Alcohol
❑ NHP Epoxy Mixing Sticks
❑ NHP Epoxy Mixing Cups
Step 1: Cutting Out the Ailerons
❑ Turn one wing panel upside down, so the molded aileron
hinge groove is facing up toward you.
❑ Use a modeling knife and a ruler to carefully cut out the
inner and outer end of the aileron at each end of the groove.
☞
Make the cuts perpendicular to the trailing edge of
the wing.
❑ Carefully flex the aileron up and down several times to free up the hinge line.
If the ailerons seem stiff, you can correct this by VERY GENTLY AND LIGHTLY dragging your modeling knife blade
down the hinge line once or twice. This will make a very shallow cut in the hinge line and reduce the stiffness. Be
careful not to cut through the hinge line!
❑ Repeat the previous procedures to cut out the aileron on the second wing panel.