Specifications

32
Need help or have any questions? Call us at 1-714-963-0329 or send us an email to [e-mail]
❑ Attach the servo horn to the Z-Bends, then attach the
servo horn to the servo, making sure that it's centered.
☞
You will have to enlarge the holes in the servo arms using
a 1/16" drill bit so that you can attach the pushrods.
❑ Install and tighten the servo horn retaining screw, provided
with your servo, to secure the servo horn into place.
❑ Kwik Bond 5 Minute Epoxy
❑ Kwik Bond Thin C/A
❑ Ruler
❑ Pencil
❑ 220 Grit Sandpaper w/Sanding Block
YOU'LL NEED THE FOLLOWING PARTS:
❑ (2) Prebent Main Landing Gear Wires
❑ (2) Plastic Main Gear Wheels
❑ (2) Plastic Main Gear Wheel Retainers
SECTION 11: MAIN LANDING GEAR INSTALLATION
❑ (2) Rubber Bands
❑ (2) Nylon Main Landing Gear Mounts
YOU'LL NEED THE FOLLOWING TOOLS AND SUPPLIES:
❑ Paper Towels
❑ Rubbing Alcohol
❑ NHP Epoxy Mixing Sticks
❑ NHP Epoxy Mixing Cups
If you plan on strictly flying your Tangent EP off of grass we suggest not installing the main gear assembly. The main
gear is not necessary for landing on grass and will only cause complication.
Step 1: Installing the Landing Gear Wires
❑ Carefully push the prebent loop in each landing gear wire
through the molded slot in the two nylon landing gear mounts.
☞
Make sure the prebent loop is pushed into the slot as far
as possible, as shown.
☞
If you ever want to remove the landing gear after it has been glued to the wing, you can simply squeeze the prebent
loop together and pull the wire from the nylon mount.