User's Manual

OPERATION
3. Press and hold until the LED changes to green (about 2 seconds).
4. To reconfi gure the dimmer to control non-fl uorescent loads, repeat the
above steps 1-3, but press the bottom of the device paddle rather
than
in step 2; the LED briefl y fl ashes green to confi rm the cancellation
of fl uorescent operation.
Tap once Fade the circuit to its last-used level
Tap twice Full bright
—
— Press and hold Increase the present level
Tap once Fade the circuit to OFF
—
— Press and hold Decrease the present level
The dimmer may feel warm to the touch during normal operation.
Replacing Lamps
When a lamp must be replaced, use the Air Gap Isolation feature for safety.
To activate the feature:
Press
FIRMLY, so that the paddle clicks and latches in. Make sure the status
LED is extinguished, indicating that it’s safe to relamp.
To release and return to normal operation, press
.
Power Fail Memory
After a power failure, all Miro devices automatically return to the state they
were in immediately prior to loss of power. All confi guration and scene control
information is preserved.
When you
see
in the
instructions,
touch the top of
the switch as
directed.
When you
see
in the
instructions,
touch the
bottom of
the switch as
directed.
ii_DRD40_10346r2 090209.indd 8ii_DRD40_10346r2 090209.indd 8 2/10/2009 3:05:47 PM2/10/2009 3:05:47 PM