User Manual

WATLOW Series 998 User’s Manual 4.13

Setup Menus, Chapter 4

Calibration Offset 2

Offset the channel B signal by a positive or negative value. This allows

you to compensate for lead resistance, sensor errors or other factors.

[CAL2] This prompt appears only if [`In2] is not set to [``no].

If Default

↓↓

[``°F] [-999] … [```0] … [`999]

[`C_F] [CAL2] [CAL2] [CAL2]

(Global Menu)

[``°F]

[`r†d] [-9(9] … [``)0] … [`9(9]

[`C_F] [`In2] [CAL2] [CAL2] [CAL2]

(Global Menu) (Input Menu)

[``°C] [-555] … [```0] … [`555]

[`C_F] [CAL2] [CAL2] [CAL2]

(Global Menu)

[``°C]

[`r†d] [-5%5] … [``)0] … [`5%5]

[`C_F] [`In2] [CAL2] [CAL2] [CAL2]

(Global Menu) (Input Menu)

[-999] … [```0] … [`999]

units

a process input

[CAL2] [CAL2] [CAL2]

is selected

RTD Calibration Curve 2

Select the calibration curve for the channel B RTD 2 input. The RTD

input uses either the European (DIN, 0.003850Ω/Ω/°C) or the Japanese

(JIS, 0.003916Ω/Ω/°C) linearization standard.

[rtd2] This prompt appears only if you have set [`In2] to [`rtd] or

[`r†d].

Default

↓

[`din] [`JIS]

[rtd2] [rtd2]

Setup-Input

[CAL2]

[rtd2]