User Manual

4.2 WATLOW Series 998 User’s Manual
Setup Menus, Chapter 4
Figure 4.2 -
The Input Menu.
Setup-Input
❸ Select the Input Menu, then
press the Mode key µ to step
through the prompts.
❹ Press the Up-arrow key > or
the Down-arrow key < to select
one of the prompt values.
[```)]
[DEC1]
[``)0]
[DEC1]
[)000]
[DEC1]
[`)00]
[DEC1]
>
>>
>
*Prompts may not appear, depending
on controller configuration.
Reaching the Input Menu
→ [InPt] Input Menu
µ
[`SEt] Setup Menus
↓
?
µ
[`In1] Input 1 (page 4.5)
↓ ?
µ
[dEC1] *Decimal 1
↓ ?
µ
[`rL1] Range Low 1
↓ ?
µ
[`rH1] Range High 1
↓ ?
µ
[CAL1] Calibration Offset 1
↓ ?
µ
[rtd1] *RTD Calibration Curve 1
↓ ?
µ
[Ftr1] Input 1 Software Filter
↓ ?
µ
[`In2] *Input 2 (page 4.10)
↓ ?
µ
[deC2] *Decimal 2
↓ ?
µ
[`rL2] *Range Low 2
↓ ?
µ
[`rH2] *Range High 2
↓ ?
µ
[CAL2] *Calibration Offset 2
↓ ?
µ
[rtd2] *RTD Calibration Curve 2
↓ ?
µ
[Ftr2] *Input 2 Software Filter
↓ ?
µ
[Lin2] *Input 2 Linearization
↓ ?
←µ [`Alt] *Altitude
Enter your settings,
from the controller’s
upper display.
TLTL
W
W
A
PROCESS
DISPLAY
MODE
1A 2A 1B 2B
CH A
CH B
SERIES 998
AUTO
MAN