User guide

6.2 ■ Parameters Watlow Series 97
Parameter Setup Order
°C or °F [`C-F]
Output 1 [Out1]
Output 2 [Out2]
Output 3 [Out3]
Output 4 [Out4]
Sensor Type [Sen1]
Input 1 [In`1] O
Range High 1 [rh`1] CDDC
Range Low [rL`1] CDDC
Decimal 1 [DeC1] DD
Calibration Offset 1 [Cal1] CDDC
Input Software Filter 1 [Ftr1] DD O
Input 2 [In`2]
Event Function [E`fn] O
Event Condition [E`cn] O
Analog Output 4 [Aout] DD
Analog Output High [A`hi] CDDC
Analog Output Low [A`lo] CDDC
Analog Output Offset [ACAL] CDDC
Alarm Hysteresis 2, 3, 4 [hys2] 3] 4] CDDC
Alarm Latching 2, 3, 4 [Lat2] 3] 4]
Alarm Silencing 2, 3, 4 [Sil2] 3] 4]
Alarm Active Sides 2, 3, 4 [Sid2] 3] 4]
Alarm Logic 2, 3, 4 [Lgc2] 3] 4]
Alarm 2, 3, 4 High [A2hi] 3] 4] CDDC
Alarm 2, 3, 4 Low [A2lo] 3] 4] CDDC
Changing this
Affects this
°C or °F [`C-F] Output 1 [Out1] Output 2 [Out2] Sensor Type [Sen1] Input 1 [In`1] Range High 1 [rh`1] Range Low [rL`1] Decimal 1 [DeC1] Input 2 [In`2]
Key:
D = Changing will change
the default
C = Changing will convert
the
temperature scale
O = Other
effect
Table 6.2 — Set up
parameters in this
order.