Owner manual

Watlow Series 935B User’s Manual 33

15 45

Convection Oven Application

Scenario

A master chef bakes bread at 350°F for 30 minutes. He wants the oven at the proper temperature with

an indication when it is ready to begin baking. He isn't concerned if the oven is 10° cool at first. After

he loads the oven, the chef wants to start the countdown time by pressing a key. When the baking

time is complete, he wants a 10 second audible indication that the bread is done.

Recommended Control

A Series 935B-1CCX

-000X control.

• Switched dc Output 1 wired to a dc input solid state relay (SSR) switches the heaters.

• Switched dc Output 2 wired to a DC SSR-T0 SSR-240-10A-DC1 or A External Mechanical Relay

audible indicator provides “done” indication.

Configuration Menu Set-up

[`C_F] = [``°f] °F

[dIsp] = [Acti] After a ß press, actual temperature appears for 15 seconds.

[`Ot1] = [hEAt] Heating output

[`Ot2] = [tMS] Time; minutes:seconds

[`rts] = [`off] RTS must be set to OFF in this application

[tIM] = [SGon] Output 2 turns ON briefly at the end of the timing cycle.

[Strt] = [rdYA] Timer waits to countdown until temperature deviation

from set point <

[`rdy] value and the ß key is pressed.

[`rdY] = [``10] Ready band; 10°F

[``St] = [``10] Output 2 turns ON for 10 sec. at the end of the timing cycle.

Operations Menu Set-up

[tMr] = [3000] Bake time; 30 minutes

[IdLE] = [``75] The set point temperature before a timing cycle starts and

after a timing cycle completes.

Set Point = [`350°F

Operator/Control Actions

• With the oven "idling" at 75°F, the chef starts the preheat cycle with a , press. The display

immediately shows 30:00 with the colon ON steadily. The RDY LED is off. Series 935B begins to

control to the 350°F bake set point.

• As the actual oven temperature increases to within the Ready Band at 350°F ±10°F, the RDY LED

turns on. The chef loads the oven and presses ß to acknowledge the Ready Band and thereby

start the bake cycle.

• Time starts counting down. Actual temperature displays for 15 seconds after the ß key is press.

Then time displays with the colon flashing.

• If temperature deviates out of the Ready Band (less than 340°F or more than 360°F), timer

countdown will pause, but will continue as soon as temperature re-enters the ready band.

• When time reaches 00:00, Output 2 turns on for 10 seconds sounding the audible indicator.

The chef can stop the audible indicator by pressing .. The Series 935B then automatically

shifts to the 75°F idle set point.

Timer Example Application