Manual

Chapter 16: Cross-Referencing LogicPro User’s Guide
256 Watlow Anafaze Doc.# 28002-00 Rev 3.00
• If Cross Reference is checked, choose whether the All
Elements or only Coils are included in the cross-
reference output.
LogicPro automatically resizes Ladder diagrams to fit the
page. This results in smaller images.
Figure 16.5 Ladder Setup Dialog Box
SFC Setup
In the SFC Setup dialog box, as shown in Figure 16.6, you
can select what information is included in reports for each
SFC. For example, you can specify:
• If the SFC graphic is output, by selecting Graphic.
• If a cross-reference of the Variables in the SFC is output,
by selecting Cross Reference.
Figure 16.6 SFC Setup Dialog Box