User guide

Watlow EZ-ZONE
®
RMH Module • 79 • Chapter 4 Setup Page
RM High Density Module • Setup Page
Display
Parameter Name
Description
Range Default
Modbus
Relative
Address
CIP
Class
Instance
Attribute
hex (dec)
Probus
Index
Parameter
ID
Data
Type
&
Read/
Write
[trgt]
[trgt]
Counter (1 to 24)
Target Value
Set the value that will turn
the output value on.
0 to 9,999 9,999 12246
[offset 40]
0x82 (130)
1 to 24
0xE (14)
158 30014 uint
RWES
[`lAt]
[ LAt]
Counter (1 to 24)
Latching
If enabled, output will latch
when count equals target
value.
No (59)
Yes (106)
No 12252
[offset 40]
0x82 (130)
1 to 24
0x11 (17)
160 30017 uint
RWES
[`LgC]
[`Set]
Logic Menu
[``Fn]
[ Fn]
Logic (1 to 24)
Function
Set the operator that will
be used to compare the
sources.
[`oFF] Off (62)
[`And] And (1426)
[nAnd] Nand (1427)
[``or] Or (1442)
[`nor] Nor (1443)
[```E] Equal To (1437)
[``nE] Not Equal To (1438)
[`LAt] Latch (1444)
[rs;ff] RS Flip-Flop (1693)
Off 9404
[offset 80]
0x7F (127)
1 to 24
0x21 (33)
177 27033 uint
RWES
Note:
Some values will be rounded off to fit in the four-character display.
Full values can be read with other interfaces.
Note:
If there is only one instance of a menu, no submenus will appear.
** These parameters/prompts are available in these menus with firmware revisions 6.0 and
above.
R: Read
W: Write
E: EEPROM
S: User
Set