User Manual
Watlow EZ-ZONE
®
RME Module • 56 • Chapter 4 Setup Page
RME Module • Setup Page
Dis-
play
Parameter Name
Description
Range Default
Modbus
Relative
Address
CIP
Class
Instance
Attribute
hex (dec)
Profibus
Index
Param-
eter
ID
Data
Type
&
Read/
Write
[sfn;B]
[SFn.b]
Timer (1 to 8)
Source Function B
Set the type of function
that will be used to reset
a retentive timer which is
the timer reset signal.
[none] None (61)
[ALM] Alarm (6)
[`C;Pr] Cool Power, Control
Loop (161)
[`CPE] Compare (230)
[`Ctr] Counter (231)
[`dio] Digital I/O (1142)
[Ent;A] Profile Event Out
A (233)
[Ent;b] Profile Event Out
B (234)
[Ent;C] Profile Event Out
C (235)
[Ent;d] Profile Event Out
D (236)
[Ent;E] Profile Event Out
E (247)
[Ent;F] Profile Event Out
F (248)
[Ent;g] Profile Event Out
G (249)
[Ent;h] Profile Event Out
H (250)
[`FUn] Function Key
(1001)
[`lgC] Logic (239)
[SoF;1] Special Function
Output 1 (1532)
[SoF;2] Special Function
Output 2 (1533)
[SoF;3] Special Function
Output 3 (1534)
[SoF;4] Special Function
Output 4 (1535)
[tMr] Timer (244)
[`uAr] Variable (245)
None 4942
[offset 50]
0x83 (131)
1 to 8
2
- - - - 31002 uint
RWES
[`si;B]
[ Si.b]
Timer (1 to 8)
Source Instance B
Set the instance of the
function selected above.
1 to 250 1 4946
[offset 50]
0x83 (131)
1 to 8
4
- - - - 31004 uint
RWES
[`s2;B]
[ SZ.b]
Timer (1 to 8)
Source Zone B
Set the zone of the function
selected above.
0 to 16 0 4950
[offset 50]
0x83 (131)
1 to 8
6
- - - - 31006 uint
RWES
[sas;b]
[SAS.b]
Timer (1 to 8)
State Active Source B
Set what state will be read
as on.
[high] High (37)
[LoW] Low (53)
High 4962
[offset 50]
0x83 (131)
1 to 8
0x0C (12)
- - - - 31012 uint
RWES
[``ti]
[ ti]
Timer (1 to 8)
Time
Set the time span that will
be measured.
0 to 9,999.000 1.0 4964
[offset 50]
0x83 (131)
1 to 8
0x0D (13)
224 31013 float
RWES
Note:
Some values will be rounded off to fit in the four-character display. Full values can be read
with other interfaces.
Note:
If there is only one instance of a menu, no submenus will appear.
** These parameters/prompts are available in these menus with firmware revisions 6.0 and
above.
R: Read
W: Write
E: EEPROM
S: User Set