User Manual

Using the 8LS
8LS User’s Guide 43
Operator Menus
You can perform these tasks from Single Loop display.
Changing the Setpoint
Press CHNG SP from the loop you want to change. This display
appears:
•
Press
Yes
to change the setpoint.
•
Press
Yes
or
No
to change the setpoint value.
•
Press
Enter
to save your changes and return to Single Loop display.
•
Press
No
or
Back
to return to Single Loop display without saving the
new setpoint.
Selecting Status Mode
•
Press
Man/Auto
from the loop you want to change. This display
appears:
•
Press
No
to switch between Auto, Manual, and Tune.
•
Press
Yes
and then
Enter
to store your choice.
•
Press
Back
if you want to go back to Single Loop display without
changing the mode.
1234 56 78
LOOP PROCESS UNITS
ALARM
SETPOINT
STATUS
OUTPUT%
5
SP ? 25
1234
567
8
LOOP PROCESS UNITS
ALARM
SETPOINT
STATUS
OUTPUT%
6 = AUTO
SET? TUNE