User`s manual

6.8 WATLOW Series 982 User’s Manual
Factory Menus, Chapter 6
Restore
Restores the original factory calibration values. This is a simple way
to recover from a mistake made while calibrating the controller.
[`rSt] This prompt always appears.
Default
↓
[``no] [`yes]
[`rSt] [`rSt]
Default
Set the operating parameter defaults to domestic or international
measures.
• [``US] (domestic) sets the controller to °F; rate in minutes; proportional
band in degrees or units; and reset in repeats per minute.
• [``SI] (international) sets the controller to °C; derivative in minutes;
proportional band in percent of span; and integral in minutes per repeat.
[`dFL] This prompt always appears.
Default
↓
[``US] [``sI]
[`dFL] [`dFL]
Factory-Calibration
[`rst]
[`dfl]