User`s manual

→ [diAg] Diagnostics Menu
↑
µ
[FctY] Factory Menus
↓
?
µ
[dAtE] Factory Ship Date (page 6.3)
↓ ?
µ
[SOFt] Software Revision
↓ [Sn--]
µ
[----] Serial Number
↓ ?
µ
[AMb] Ambient Temperature
↓ ?
µ
[Acnt] Ambient A/D Count
↓ ?
µ
[`gnd] Ground A/D Count
↓
?
µ
[cnt1] Input 1 A/D Count (page 6.4)
↓ ?
µ
[cnt2] Input 2 A/D Count
↓ ?
µ
[itY1] Input 1 Module
↓ ?
µ
[itY2] Input 2 Module
↓
?
µ
[OtY1] Output 1 Module (page 6.5)
↓ ?
µ
[Oty2] Output 2 Module
↓ ?
µ
[Oty3] Output 3 Module
↓ ?
µ
[Oty4] Output 4 Module
↓ ?
µ
[dISP] Test Displays
↑
↓ ?
←
µ
[tout] Test Outputs
6.2 WATLOW Series 982 User’s Manual
Factory Menus, Chapter 6
Figure 6.2 -
The Diagnostics
Menu.
Factory-Diagnostics
❸ Select the Diagnostics Menu
[diag], then press the Mode key µ
to step through the prompts.
❹ Press the Up-arrow key > or the
Down-arrow key < to select one of
the prompt values.
In the Diagnostics Menu only the val-
ues of [dISP] and [tout] can be
changed.
TL
W
W
A
PROCESS
L1 L2 L3 L4
DEV
% OUT
DISPLAY
SERIES 982
MODE
HOLD
RUN
Reaching the Diagnostics
Menu
[``no][`YES]
[dISP] [dISP]
[
`OFF][out1] … [out4]
[tout] [tout] [tout]
Enter your settings,
from the controller’s
upper display.