User`s manual

5.14 WATLOW Series 982 User’s Manual
Operation Menus, Chapter 5
Operation-PID
Output 1 Cycle Time
Select the time, in seconds, of a complete on/off cycle.
[`Ct1] This prompt appears only if [`In1] (Input Menu) is not set to a
process and [`Pb1] is set higher than [```0].
If Default
↓↓
mechanical [``%0] … [`1)0] … [99(9] sec.
relay [`Ct1] [`Ct1] [`Ct1]
outputs
open collector [brSt] [``)1] … [``!0] … [99(9] sec.
or solid-state [`Ct1] [`Ct1] [`Ct1] [`Ct1]
relay outputs
Output 2 Proportional Band
Select the proportional band for PID output 2. If set to [```0] it func-
tions as an on/off control and the switching differential is determined by
the [HYS2] value (Output Menu).
[`Pb2] This prompt appears only if [`Ot2] (Output Menu) is set to [``Ht]
or [``CL] .
If Default
↓↓
[``US]
&
[``°F] [```0] … [[``25] … [`999]
[`dFL] [`C_F] [`Pb1] [`Pb1] [`Pb1]
(Calibration Menu) (Global Menu)
&
[`r†d] [``)0] … [[``25] … [99(9]
[`In1] [`Pb1] [`Pb1] [`Pb1]
(Input Menu)
[``US]
&
[``°C] [```0] … [[``14] … [`555]
[`dFL] [`C_F] [`Pb1] [`Pb1] [`Pb1]
(Calibration Menu) (Global Menu)
&
[`r†d] [``)0] … [[``14] … [99(9]
[`In1] [`Pb1] [`Pb1] [`Pb1]
(Input Menu)
[``SI] [``)0] … [``#0] … [`9(9]
% of span
[`dFL] [`Pb1] [`Pb1] [`Pb1]
(Calibration Menu)
[`Pb2]
[`Ct1]
NOTE:
For more informa-
tion on burst fire,
[brSt], see
Chapter 9.