User`s manual

Power Outage
Select what will happen when power is lost, then restored. Make sure
the backup battery DIP switch is on (see Chapter 1).
• [Cont] continues running the profile from the point at which it was
interrupted.
• [HOld] maintains the set point in effect when the power was interrupted.
• [Abrt] quits running the profile, displays [`OFF] in the lower display
and turns off all outputs.
• [IdSP] maintains the set point selected at the idle set point prompt
[IdSP] (the next prompt).
• [rSEt] resets the program to step 1.
• If [Hold], [Abrt] or [IdSP] is selected, the lower display alternately
flashed [Pout] and the current parameter. Press / to clear it.
[Pout] This prompt always appears.
Default
↓
[Cont] [HOLd] [Abrt] [IdSP] [rSEt]
[Pout] [Pout] [Pout] [Pout] [Pout]
WATLOW Series 982 User’s Manual 4.35
Setup Menus, Chapter 4
[Pout]
Setup-Global