User`s manual

4.28 WATLOW Series 982 User’s Manual
Setup Menus, Chapter 4
Setup-Global
❸ Press the Mode key µ to step
through the prompts.
❹ Press the Up-arrow key > or
the Down-arrow key < to select
one of the prompt values.
Input 
Menu 
p. 4.2
Output 
Menu 
p. 4.12
Global 
Menu 
p. 4.28
Communications
Menu 
p. 4.38
❶ Begin in the Display Loop, and
press the Up-arrow > and Down-
arrow < keys simultaneously for
three seconds to reach the Setup
Menus.
❷ Press the Up-arrow key > to
select one of the Setup Menus.
Reaching the Global Menu
Figure 4.28 -
Navigating the
Global Menu.
*Prompts may not appear, depending
on controller configuration.
[``°F] [``°C]
→ [gLbL] Global Menu
↑
µ
[`SEt] Setup Menus
↓
?
µ
[`C_F] *Celsius-Fahrenheit (page 4.29)
↓ ?
µ
[`Err] Error Latching
↓ ?
µ
[`Ei1] Event Input 1
↓ ?
µ
[`Ei2] *Event Input 2
↓ ?
µ
[AbSP] *Abort Set Point
↓ ?
µ
[Anun] Annunciator
↓ ?
µ
[`LoP] Low Power Limit
↓ ?
µ
[`HiP] High Power Limit
↓
?
µ
[AtSP] Auto-tune Set Point (page 4.33)
↓ ?
µ
[PtYP] Program Type
↓ ?
µ
[`gSd] Guaranteed Soak Deviation
↓ ?
µ
[Pout] Power Outage
↓
?
µ
[IdSP] *Idle Set Point
↓ ?
µ
[PStr] Profile Start
↑
↓
?
←µ [`LOC] Lockout
Enter your settings,
from the controller’s
upper display.