User`s manual

WATLOW Series 982 User’s Manual 4.19
Setup Menus, Chapter 4
Setup-Output
Alarm 3
Select the alarm type for alarm 3.
• [`Pr1] uses the process signal from input 1.
• [`dE1] uses a deviation from the input 1 signal.
• [rAtE] uses the rate of change at input 1 in degrees per minute.
[`AL3] This prompt appears only on controllers equipped with output 3
hardware for a relay (98__-____-B___, 98__-____-J___ or 98__-____-K___) or
switched dc (98__-____-C___), and with [`Ot3] set to [`AL3] or [AL3n].
Default
↓
[`Pr1] [`de1] [rAtE]
[`AL3] [`AL3] [`AL3]
[`AL3]