User`s manual

4.16 WATLOW Series 982 User’s Manual
Setup Menus, Chapter 4
Setup-Output
Hysteresis 2
Select the switching hysteresis for output 2. This determines the
change in temperature or process units needed to turn the output from
full off to full on.
• If [`AL2] is set to [rAtE] settings for [HYS2] will be in degrees per
minute or units per minute.
• If the input referenced by [`AL2] is set to [`r†d] the range is affected as
listed below.
[HYS2] This prompt appears only on controllers equipped with output 2
hardware and with [`Ot2] not set to [``no]. This prompt does not appear
on controllers with [`In2] set to [SLid] or on controllers equipped with
output 2 process hardware.
If Default
↓↓
[``°F [```1] … [```3] … [`999]
[`C_F] [HYS2] [HYS2] [HYS2]
(Global Menu)
[``°F]
&
[`r†d] [``)1] … [[``#0] … [`9(9]
[`C_F] [`In1] [HYS2] [HYS2] [HYS2]
(Global Menu) (Input Menu)
[``°C] [```1] … [[```2] … [`555]
[`C_F] [HYS2] [HYS2] [HYS2]
(Global Menu)
[``°C]
&
[`r†d] [``)1] … [[``@0] … [`5%5]
[`C_F] [`In1] [HYS2] [HYS2] [HYS2]
(Global Menu) (Input Menu)
[```1] … [```3] … [`999]
units
a process input
[HYS2] [HYS2] [HYS2]
is selected
[HYS2]