User`s manual

4.12 WATLOW Series 982 User’s Manual
Setup Menus, Chapter 4
Setup-Output
❸ Press the Mode key µ to
step through the prompts.
❹ Press the Up-arrow key > or
the Down-arrow key < to
select one of the prompt values.
Input 
Menu 
p. 4.2
Output 
Menu 
p. 4.12
Global 
Menu 
p. 4.28
Communications

Menu 
p. 4.38
❶ Begin in the Display Loop,
and press the Up-arrow > and
Down-arrow < keys simulta-
neously for three seconds to
reach the Setup Menus.
❷ Press the Up-arrow key > to
select one of the Setup Menus.
…
…
…
Reaching the Output
Menu
Figure 4.12 -
Navigating the
Output Menu.
*Prompts may not
appear, depending
on controller config-
uration.
→
[OtPt] Output Menu
↑
µ
[`SEt] Setup Menus
↓
?
µ
[`Ot1] Output 1 (page 4.13)
↓ ?
µ
[Prc1] *Process 1
↓ ?
µ
[HYS1] Hysteresis 1
↓
?
µ
[`Ot2] *Output 2 (page 4.15)
↓ ?
µ
[Prc2] *Process 2
↓ ?
µ
[HYS2] *Hysteresis 2
↓ ?
µ
[`AL2] *Alarm 2
↓ ?
µ
[LAt2] *Latching 2
↓ ?
µ
[SIL2] *Silencing 2
↓
?
µ
[`Ot3] *Output 3 (page 4.19)
↓ ?
µ
[`AL3] *Alarm 3
↓ ?
µ
[HYS3] *Hysteresis 3
↓ ?
µ
[LAt3] *Latching 3
↓ ?
µ
[SIL3] *Silencing 3
→
→ ?
µ
[`Ot4] *Output 4 (page 4.22)
↓ ?
µ
[`AL4] *Alarm 4
↓ ?
µ
[HYS4] *Hysteresis 4
↓ ?
µ
[LAt4] *Latching 4
↓ ?
µ
[SIL4] *Silencing 4
↓
?
µ
[Aout] *Analog Output (page 4.25)
↓ ?
µ
[Prc3] *Process 3
↓ ?
µ
[`ArL] *Retransmit Low Limit
↓ ?
µ
[ArH] *Retransmit High Limit
↑
↓ ?
←µ [ACAL] *Retransmit Calibration Offset
Enter your settings,
from the controller’s
upper display.