User`s manual

WATLOW Series 982 User’s Manual 4.9
Setup Menus, Chapter 4
Setup-Input
Range High 2
Select the high resistance of the slidewire potentiometer.
[`rH2] This prompt appears only on controllers with [`In2] (Input Menu)
set to [SLiD].
Default
↓
[`rL2] … [```0] … [1200]
[`rH2] [`rH2] [`rH2]
Learn Low
Write the low-end resistance of the slidewire potentiometer to the
range low 2 parameter.
[LrnL] This prompt appears only on controllers with [`In2] (Input Menu)
set to [SLiD].
Default
↓
[``no] [`YES]
[LrnL] [LrnL]
Learn High
Write the high-end resistance of the slidewire potentiometer to the
range low 2 parameter.
[LrnH] This prompt appears only on controllers with [`In2] (Input Menu)
set to [SLiD].
Default
↓
[``no] [`YES]
[LrnH] [LrnH]
[`rH2]
NOTE:
See Chapter 9 for
more information
on slidewire feed-
back.
[LrnL]
[LrnH]
NOTE:
These values do not
affect the low or the
high set point limit
for process alarms.