User`s manual

Watlow Series SD ■ 45 ■ Chapter 8 Profiling
*Exit menu refers to returning back to the display of process value in the upper display and active set point value in the lower display. The
ramping set point will be active while running a profile and the manual adjustable set point will be active when a profile is not running.
**The Lockout parameter in the Setup Page determines your level of access to the other pages and menus, including the Pre-Run and Run
menus.
How to Navigate the Profiling Menus
Pre-Run Menu**
The Pre-run prompts are only visible when in the Pre-Run mode. The Pre-Run mode is entered by pressing the
Infinity ˆ key one time while at the Home Page. The profile indicator light flashes while in the Pre-Run mode. The
menu consists of the File [file], Step [step], and Select [SelC] prompts. It allows the user to stop or start a pro-
file. When no profile is running, entering the Pre-run menu allows the selection of a profile and step number to
run. Pressing the Advance ‰ key toggles between the two prompts. Pressing the Infinity ˆ key at the [Step]
prompt will start the profile. Pressing the Infinity ˆ key at the [File] prompt will exit the pre-run menu without
starting the profile. Pressing the Infinity ˆ key while a profile is running or on hold will activate the [SelC]
prompt. The profile indicator light flashes when [SelC] is displayed. The prompt allows you to choose to hold the
profile [hold], turn off the profile [~Off] or resume running a profile [resU].
Pre-Run Menu - Profile off
[File] File to start profile with
[Step] Step to start profile on
Pre-Run Menu - Profile Run or Hold
[hold] Hold current profile [~Off] Terminate profile [resU] Resume running current profile
[SelC] [SelC] [SelC]
Note: If there isn’t any key press activity for 15 seconds while in the Pre-Run Menu, the controller exits the Pre-Run Menu and returns to the
Home Page.
Pre-Run Menu -
Profile Off
Pre-Run Menu -
Profile Run or Hold
Profile Menu Run Menu
Menu function Start a profile. Holding, resuming or stop-
ping a profile.
Programming a profile. Viewing profile status.
Enter menu
Press the Infinity ˆ key. Press the Infinity ˆ key. Press the Advance ‰ key.
At the [Prof] prompt, se-
lect [~yes].
Press the Advance ‰ key.
Scroll through menu
Press the Advance ‰ key.
N/A
Press the Advance ‰ key. Press the Advance ‰ key.
Change prompt values
Press the Up ¿ or down ¯
key.
Press the Up ¿ or down ¯
key.
Press the Up ¿ or down ¯
key.
Read only.
Exit menu*
Press the Infinity ˆ key at
the [File] prompt.
Select the desired mode
and press the Infinity ˆ
key.
Press the Infinity ˆ key. Press the Infinity ˆ key.
Start profile
Press the Infinity ˆ key
while at the [Step]
prompt.
N/A N/A N/A