User`s manual

Ó
Warning:
Use National Electric (NEC)
or other country-specific
standard wiring and safety
practices when wiring and
connecting this controller to
a power source and to elec-
trical sensors or peripheral
devices. Failure to do so may
result in damage to equip-
ment and property, and/or
injury or loss of life.
Watlow EZ-ZONE™ RUI/Gateway • 6 • Chapter 2 Install and Wire
EtherNet/IP™ and Modbus TCP Communications
receive -
unused
E8
E7
E6
E5
E4
E3
E2
E1
Slot B
unused
unused
unused
receive +
transmit -
transmit +
RJ-45
pin
T568B wire
color
Signal Slot
B
8 brown unused E8
7 brown & white unused E7
6 green receive - E6
5 white & blue unused E5
4 blue unused E4
3 white & green receive + E3
2 orange transmit - E2
1 white & orange transmit + E1
• Do not route network
wires with power wires.
• Connect one Ethernet
cable per device to a
10/100 mbps ethernet
switch. Both Modbus
TCP and EtherNet/IP™
are available on the
network.
EtherNet/IP™ and Mod-
bus TCP communica-
tions to connect with a
10/100 switch.
DeviceNet™ Communications
CAN_L
V-
V+
CH
SH
CL
V-
T2
S2
R2
Slot B
V+
CAN_H
shield
Terminal Signal Function
V+ V+ DeviceNet™ power
CH CAN_H positive side of DeviceNet™
bus
SH shield shield interconnect
CL CAN_L negative side of DeviceNet™
bus
V- V- DeviceNet™ power return