User`s manual

Watlow EZ-ZONE™ RUI/Gateway • 17 • Chapter 5 Networking with a Gateway
gtW 1 = PM1
gtW 4 = PM4
Com Instance 1
Standard Bus Address
Ad;S = 1-8
Start Node to Scan
St;2n = 1-16
End Zone to Scan
nU;2n = 1-16
Network Baud Rate
baud = 125, 250. or 500Kb
Com Instance 2
DeviceNet Node Address
Ad;d = 0-63
DeviceNet Quick Connect
Fc;e = Yes or No
RUI/Gateway (gtW) Setup Prompts
gtW = 1 – 16
(Gateway Instance)
Du;En = Yes or No
(Enable gateway instance)
Gateway
Du;st = On or off
(Device Status)
Watlow Standard Bus
(Daisy chain EIA-485)
EZ-ZONE Controllers
1 - 16 maximum
CIP Offset
1-3
CIP Offset
5-7
CIP Offset
9-11
CIP Offset
13-255
oSt = 0 - 255
(CIP Offset)
A;nb = 0 - 20
(CIP Assembly Size)
DeviceNet (CIP Networks)
Note: To minimize traffic and enable better throughput on Stan-
dard Bus, set the End Zone prompt in the RUI to the maximum
number of EZ-ZONE controllers on the network to be scanned.