User`s guide

Series D8 User’s Guide Chapter 7: Troubleshooting and Reconfiguring
Doc. 0600-3120-2000 Watlow Anafaze 177
Configuring Dual DAC Outputs
Dual DAC modules ship with both of the outputs configured
for the signal type and span that were ordered. The module
contains two independent circuits (DAC 1 and DAC 2). These
circuits can be configured for different output types. Remove
the board from the housing and set the jumpers. The odd-num-
bered jumpers determine the signal from DAC 1; the even-
numbered jumpers determine the output from DAC 2.
Figure 7.6 Dual DAC
Table 7.10 Dual DAC Jumper Settings
Output
Type
Jumper Settings
1/2 3/4 5/6 7/8 9/10 11/12 13/14
0 to 5 Vdc B A A O B A O
0 to 10 Vdc B A A O B O O
4 to 20 mA O A B A A O A
A = Load jumper in the “A” position, or load jumper if header has
only two pins.
B = Load jumper in the “B” position.
O = Open. Do not load jumper.
1 2 3 4 5 61 2 3 4 5 6
1 2 3 4 5 6
+5V IN
DZC IN
+10-24V IN
V OUT
I SINK
OUT COM
+5V IN
DZC IN
+10-24V IN
V OUT
I SINK
OUT COM
DAC 2
DAC 1
ANAFAZE
DUAL DAC