User`s manual

Watlow EZ-ZONE™ Communications • 50 • Chapter 4 DeviceNet
Figure 4.16
Again note that both of the above screen shots represent the factory defaults and that each member can
be changed. Now create two controller tags that will use the data types just created in figure 4.15 and 4.16.
As can be seen below the tag name is identified as PMDnet_T_to_O. Notice the data type selected (arrow, fig-
ure 4.17). Notice too, that the first member is identified as "Module Status"; bit 12 and bit 16 represent good
communications between the DeviceNet card and the PM.
Figure 4.17
Figure 4.18