User`s manual

Watlow EZ-ZONE™ Communications • 47 • Chapter 4 DeviceNet
3. Once the upload is complete click on the "Platform" drop down box and select the appropriate control.
In this case, the PM is connected to a CompactLogix. This selection will have an impact on the addres
ing for the MicroLogix is a 16-bit machine where the CompactLogix is 32-bits.
4. After selecting the CompactLogix as the platform click on the "Scanlist" tab. As figure 4.12 shows, the
scanner will display all available devices on the network and all of those currently in the scanlist. In
this case there is only one device on the network.
5. Click on the Watlow EZ-ZONE™ control and then click on the right arrow button located in the mid
dle of the screen. Since the "Automap on Add" check box is checked when the right arrow button is
pushed the PM control will be automatically mapped into specific addresses for both the input and the
output.
Mapping the EZ-ZONE™ PM Into PLC Memory
1. Double click on your DeviceNet scanner and once open (figure 4.10) click on the "Module" tab.
2. Click the "Upload" button
Figure 4.11
Figure 4.10