User`s manual

Watlow EZ-ZONE™ Communications • 31 • Chapter 3 EtherNet/IP
I/O Configuration using an Allen-Bradley Logix Family Processor
The setup steps may vary depending on the controller. The specific control used in the examples is a Compact-
Logix 1769-L32E. Follow the steps below to add and configure the PM as a generic Ethernet module.
1. In the I/O configuration, right click on the Ethernet Port, (in this case: 1769-L32E Ethernet Port Lo-
calENB) and add a new module.
Figure 3.0
Figure 3.1
2. Select “Generic Ethernet Module” and click OK.
Configuring PM Properties using the RSLogix 5000
After clicking OK, the following screen will appear. You must complete all the fields in this screen except the
description field.