User`s guide

Setup

MLS User’s Guide 83

Heat/Cool Cycle Time

Use this menu to set the Cycle Time for Time Proportioning outputs.

Selectable range: 1-255 seconds.

NOTE

The Cycle Time menu will only be present if the out-

put type for the current loop is Time Proportioning.

SDAC Menus

If you attach the optional SDAC to an output, you must conﬁgure that

output for the SDAC using the following series of menus. The MLS will

also assign digital output #34 as a clock line for the SDAC. You won't be

able to assign another function to output #34 while any loop's output is

set to SDAC.

SDAC Mode

Use this menu to toggle the SDAC between current and voltage output.

The SDAC menus only appear if the output type for the loop is set to

SDAC.

Selectable values: Current and Voltage.

LOOP PROCESS UNITS

ALARM SETPOINT STATUS OUT%

03 HEAT OUTPUT

CYCLE TIME ? 10S

LOOP PROCESS UNITS

ALARM SETPOINT STATUS OUT%

01 SDAC MODE ?

VOLTAGE