User`s guide

Installation
MLS User’s Guide 25
Wiring Recommendations
This section gives general wiring recommendations.
DANGER
Never wire bundles of low power Watlow-Anafaze
circuits next to bundles of high power AC wiring.
Instead, physically separate high power circuits
from the controller. If possible, install high voltage
AC power circuits in a separate panel.
•
Use stranded wire. (Use solid wire for fixed service; it makes inter-
mittent connections when you move it for maintenance.)
•
Use #18 or #20 AWG wire. Larger or smaller sizes may be difficult
to install, may break easily, or may cause intermittent connections.
•
Use shielded wire. (The electrical shield protects the MLS from
electrical noise.) Connect one end of the
input wiring shield
to the
MLS panel's 120 Vac panel ground, and connect one end of the
out-
put wiring shield
to the MLS panel's 120 Vac panel ground. (If
your system requires a different shield configuration, contact Wat-
low-Anafaze for more information.)
For more information about noise suppression, see
Noise Suppression
.