User`s guide

System Setup
ANASOFT User’s Guide 41
System Terminate
•
This window allows you to terminate ANASOFT.
•
Press
Enter
when the cursor is on the “Terminate Program” mes-
sage. The program prompts as follows:
Terminate Program (Y/N)?
If you have edited the current job without saving to disk, the following
message appears:
NOTE: The current job has been changed. To save changes to job file,
use the Save Job function of the Job Setup screen before terminating
the program.
If you entered
Y
, you will be asked whether to turn all outputs Off
before terminating.
Set Control Outputs Off (Y/N)?
WARNING
Turning control outputs off will shut down the
entire process.
•
The program terminates and returns to the operating system.