User manual

Former clamp mechanism.C
#
InformationActionStep
See ‘Lift the Booklet maker Main
Deck’ on page 44
Open the Booklet maker main
deck
1
Remove the trim bin.2
The procedure can be seen from the
top of the machine (see ‘Illustration’
on page 92).
Access to the parts is through the
former clamp mechanism (see ‘Illus-
tration’ on page 92).
Hold the shaft and push to the right,
against spring pressure to disengage
the shaft from the drive pin.
Lift the left hand end clear.
Loosen the trimmer infeed
conveyor.
3
Remove the book, if one is
found.
4
Look down through the former
clamp (see ‘Illustration’ on page 92).
Small pieces of paper trimmings can
cover the jam sensor and cause an
error message.
Remove any paper offcuts from
the trimmer infeed conveyor.
5
Chapter 5 - Error Conditions, Problems and Solutions 93
Clear Paper Jams