User manual

SolutionCauseProblem
The rotate axis is moving.
This message clears when
the adjustment is com-
plete.
If the message does not
clear, touch ADVANCED
> RE REF.
Rotate axis moving
Use the mains ON/OFF
switch. Turn the machine
OFF, then turn the ma-
chine ON. If the problem
continues, then call your
service engineer.
ROTATE - No comms
There is a set or partial set
in the gathering area.
Open the gathering area
and remove the sheets.
If the print job has been
cancelled, open the gather-
ing area and remove the
sheets. Or touch START
, then touch AD-
VANCED > PURGE
SET > PURGE SET to
clear the set from the ma-
chine.
SET IN GATHERING
AREA
The shuttle axis is moving.
This message clears when
the adjustment is com-
plete.
If the message does not
clear, touch ADVANCED
> RE REF.
Shuttle axis moving
Use the mains ON/OFF
switch. Turn the machine
OFF, then turn the ma-
chine ON. If the problem
continues, then call your
service engineer.
SHUTTLE MOTOR
COMMS FAIL
Chapter 5 - Error Conditions, Problems and Solutions 83
Error Messages