User manual

SolutionCauseProblem
Use the mains ON/OFF
switch. Turn the machine
OFF, then turn the ma-
chine ON. If the problem
continues, then call your
service engineer.
MAIN CONTROL - No
comms
See ‘Manually park the
Shuttle’ on page 109
The shuttle is not parked
correctly. Open the folder
cover and move the shuttle
to the park position. Close
the folder cover. The
shuttle will reset. When
the message list is clear,
continue operation.
MANUALLY PARK
SHUTTLE
See ‘Clear a Stitch-wire
Jam’ on page 100
See ‘Install New Stitch-
wire’ on page 133
The machine has detected
missed stitches. Check if
the stitch-wire is jammed
or if the stitch-wire spool
is empty.
MISSING STITCHES
The drive motor controller
is not ready. If the prob-
lem continues, contact
your service engineer.
MOTOR CON-
TROLLER NOT READY
See ‘Operator Maintenance’
on page 112
The machine needs rou-
tine maintenance by the
operator.
OPERATOR MAINTE-
NANCE
Use the mains ON/OFF
switch. Turn the machine
OFF, then turn the ma-
chine ON. If the problem
continues, then call your
service engineer.
REBOOT THE MA-
CHINE
Open the folder cover and
remove the set.
REMOVE SET FROM
FOLD AREA
Open the gathering area
and remove the sheets.
REMOVE SET - GATH-
ERING AREA
See ‘Jam in the Stitch Area’
on page 90
Open the folder cover and
remove the set.
REMOVE SET -
STITCH AREA
Chapter 5 - Error Conditions, Problems and Solutions82
Error Messages