User manual

Re-reference the machine.
Touch ADVANCED > RE-REF > RE-REF to re-reference the machine.
Does the problem continue?
NoYes
Further action is not needed.¦
¦
V
Call your service engineer.
Trimming problem - the book is not trimmed square
Open the trim stop guard and check for paper trimmings (see ‘Clear paper from the trim
stop’ on page 138).
#
Is the trim stop clear of paper trimmings?
NoYes
Clear paper from the trim stop.
Does the problem continue?
¦
¦
¦
¦
¦
¦
V
NoYes
No further action is need-
ed.
¦
¦
V
Call your service engineer.
Trimming problem - poor trim quality
The trim process uses a double-edge blade to cut thick books. This can leave a small mark
in the centre of the trimmed edge. The visibility of this mark will depend on the paper
quality and characteristics.
Chapter 5 - Error Conditions, Problems and Solutions70
Book Quality