User manual

Adjust the NUMBER of forms setting. Increase the NUMBER

of forms to give more spine form and decrease the NUMBER

of forms to give less spine form.

Does the problem continue?

NoYes

Further action is not needed.¦

Load a Default Job. This will reset the FORM settings, includ-

ing PRESSURE, NUMBER and THRESHOLD (see ‘Reset

the Booklet maker to default settings’ on page 36).

Does the problem continue?

NoYes

Further action is not needed.¦

Run a standard job using paper of 80 g/m² (20 lb bond).

Does the problem continue?

NoYes

The problem is caused by the cover mate-

rial or the finish on the cover. Change the

cover material.

Re-reference the machine. Touch ADVANCED > RE-REF >

RE-REF to re-reference the machine.

Does the problem continue?

NoYes

Further action is not needed.¦

Call your service engineer.

Chapter 5 - Error Conditions, Problems and Solutions64

Book Quality