User manual

Clean the static elimination bars (see ‘Clean the Static Elimination Bars’ on page 115).
Does the problem continue?
NoYes
Further action is not needed.¦
¦
V
Is the paper thin and/or curly?
NoYes
Call your service engineer.¦
¦
V
Increase the TAMPER TIME to give the paper more time to settle. Supervisor access
level is needed (see ‘The MENU Window’ on page 33). On thin books, this may re-
duce the production speed. Touch CONFIGURE > SHUTTLE. Increase the
TAMPER TIME in increments of 200.
Does the problem continue?
NoYes
Further action is not needed.¦
¦
V
Call your service engineer.
Spine form problems
#
Incorrect spine form.
The spine is over-formed
and the book is damaged.
Incorrect spine form.
The square spine is part
formed or not formed.
Correct spine form
#
Is the spine form different at each end of the spine?
NoYes
Chapter 5 - Error Conditions, Problems and Solutions62
Book Quality