User manual

The CONFIGURE Window
Introduction
The CONFIGURE window lets you make changes to the configuration of the machine.
Some functions and buttons are only available at certain access levels, see 'ACCESS
LEVEL' ‘Button overview’ on page 33.
The CONFIGURE Window Buttons
Button overview#
SupervisorOperatorInformationButton
ActiveHiddenTouch MACHINE OPTIONS
to view the general machine set-
up. Some of the settings can be
changed, depending on the cur-
rent access level.
MACHINE
OPTIONS
ActiveHiddenSelect 'mm' or 'inch' as the unit
of measurement.
- MEASURE-
MENT
ActiveHiddenThere is a sensor that checks for
stitches. Touch STITCH SEN-
SOR to turn the stitch sensor on
or off. The default setting is ON.
- STITCH
SENSOR
ActiveHiddenThe preset paper sizes can be ei-
ther ISO A sizes or US paper
sizes. To select which preset pa-
per sizes are available, touch the
relevant button.
- PRESET PA-
PER SIZES
ActiveHiddenTouch SHUTTLE to make ad-
justments to the tamper.
SHUTTLE
VisibleHiddenThis button is used by the ser-
vice engineer.
-TAMPER
DELAY
ActiveHiddenTAMPER TIME adjusts the
time that the tamper touches the
set.
An increase in TAMPER TIME
causes a decrease in the produc-
tion rate for thin books.
- TAMPER
TIME
VisibleVisibleThis button is used by the ser-
vice engineer.
FORM SET-
UP
Chapter 3 - The User Interface32
The CONFIGURE Window