User manual

InformationButton
To make the square spine of the book, pressure is applied
to the spine. This process is called forming.
Touch FORM to specify the amount of spine form.
To make a good spine on different paper types, the amount
of spine form can be changed.
To change the amount of spine form:
■
Touch NUMBER to change how many times the spine
is processed
■
Touch PRESSURE to change the pressure
FORM
Touch AUTO to select the optimum amount of spine form,
according to the set thickness.
- AUTO
Touch NUMBER to select how many times the form roller
processes the spine. The available options are 1, 2, 3 or 4.
An increase in NUMBER increases the time taken to form
the spine and can decrease the production rate for thin
books. Alternatively, increase the PRESSURE.
- NUMBER
Touch PRESSURE to increase or decrease the pressure
used to form the spine.
Touch + to increase the amount of spine form. Touch - to
decrease the amount of spine form. The range is -9 to +9.
The default setting is 0.
- PRESSURE
Use THRESHOLD to choose if a square spine is formed.
If the SET THICKNESS value is thinner than the
THRESHOLD value, a square spine is not formed.
If the SET THICKNESS value is thicker than the
THRESHOLD value, a square spine is formed.
If the SET THICKNESS value is 1.5mm or thicker, a
square spine is always formed.
The default value is 0.8 mm. The allowed range is 0.1 mm
to 1.5 mm
- THRESHOLD
The trim dimension is calculated automatically according
to the PAPER SIZE and SET THICKNESS.
If needed, the trim dimension can be changed. Touch
TRIM to adjust the size of the finished book after the fore-
edge is trimmed.
The maximum trim is 28 mm. The trim function can be
turned off.
TRIM
Touch AUTO to select the default trim position.- AUTO
Chapter 3 - The User Interface28
The BASIC Window