User manual

Enter the Job Settings

Introduction

Make the settings for a new job in the BASIC window on the touch screen. See the

chapter “The User Interface” for more information.

The PAPER SIZE and PAGE DIRECTION settings are entered on the touch screen.

These dimensions refer to the format of the paper when it enters the Booklet maker.

Attention:

Do not operate the touch screen with a sharp object or with too much force. These actions

can damage the touch screen.

Before You Begin

InformationActionStep

Print a set to the

stacker.

Measure the set accurately. To make an accurate book

you must enter accurate paper dimensions into the

touch screen.

To get the best accuracy, use millimetres to measure

the set.

If needed, set the Booklet maker to use millimetres:

■

Touch MENU.

■

Select Supervisor access level.

■

Touch MENU > CONFIGURE > MACHINE

OPTIONS.

■

Touch mm > CLOSE.

Measure the sheet

size and the set

thickness.

Use these dimen-

sions for the job

setting.

Note:

This set can be made into a book (see ‘Operate the Booklet maker offline’ on page 53).

Chapter 2 - How to run the Booklet maker16

Enter the Job Settings