User manual

InformationActionStep
Move the wire holder retaining spring
to the right. Then remove the wire
holder ( see ‘Introduction’ on page 128)
Remove the wire holder from
the stitch head.
2
See Driver Bar.
30mm
Apply 30mm of grease to the
visible surface of the driver bar.
3
Fit the wire holder.4
Lubricate the wire-feed cam
#
InformationActionStep
Lift the PSQ main deck.1
See Lubricate the wire-feed cam.
10mm
Apply 10mm of grease from the
tube between the bearing surface
of the wire-feed cam and the
feed lever.
2
Lower the Booklet maker main
deck
3
Chapter 6 - Maintenance 131
Lubricate the Stitch Head