User manual

Change the fuses of the Book Stacker
Introduction
The Book Stacker has 2 fuses at the power input connector (see ‘Illustration’ on page 12).
If either fuse is broken, the Book Stacker will not operate.
Required tool
■
3A, HRC Quick acting, F
Attention:
Turn OFF the machine and remove the mains power supply cable before you change the
fuses. This machine uses two fuses in parallel.
Attention:
To avoid the risk of fire, replace fuses using only the same type and rating.
Procedure
1.
Turn OFF the Book Stacker.
2.
Disconnect the Book Stacker from the power supply.
3.
Check each fuse.
4.
If the fuse is broken then replace with a fuse of the correct specification.
Note:
If the fuse breaks again, then call your service engineer.
Chapter 5 - Error Conditions, Problems and Solutions108
Change the fuses of the Book Stacker