User manual

Change the fuses of the Booklet maker
Introduction
The Booklet maker has 2 fuses at the mains power input (see ‘The Rear Panel of the
Booklet maker’ on page 11). If either fuse is broken, the Booklet maker will not operate.
Required tool
■
Fuse description: 7A, HRC Quick Acting, F
Attention:
Turn OFF the machine and remove the mains power supply cable before you change the
fuses. This machine uses two fuses in parallel. To avoid the risk of fire, replace fuses using
only the same type and rating.
Procedure
1.
Turn OFF the Booklet maker.
2.
Disconnect the Booklet maker from the mains power supply.
3.
Turn one fuse-holder to the left and remove the fuse-holder from the Booklet maker.
4.
Check the fuse.
5.
If the fuse is broken then replace with a fuse of the correct specification.
6.
Repeat the procedure for the other fuse.
Note:
If the fuse breaks again, then call your service engineer.
Chapter 5 - Error Conditions, Problems and Solutions 107
Change the fuses of the Booklet maker