User manual

InformationActionStep
■
Move the wireholder retaining
spring to the right. ‘Procedure 2’ on
page 103
■
Remove the wire-holder
If the wire-holder is held in position,
use a screw driver to help the removal
of the wire-holder from the stitch head.
Attention: Do not apply force to the
wire guide bars or the pivot block (see
‘Procedure 3’ on page 103).
Remove the wire-holder from
the stitch head.
2
‘Procedure 3’ on page 103Inspect the area behind the
wire-holder for stitch-wire.
3
Use the wire-cutters to remove any
jammed stitches or pieces of stitch-
wire.
Remove any stitches or pieces
of stitch-wire and clean the
area with the air-duster.
4
‘Lubricate the Stitch Head’ on page 128Lubricate the stitch-head.5
Remember to put the wire-holder re-
taining spring in position.
Fit the wire-holder.6
Close the Booklet maker.7
If the head operates normally and re-
turns to the parked position, then fur-
ther action is not needed.
If the stitch-head remains jammed,
then repeat the procedure one time.
If the problem continues, then contact
your service engineer.
Start the Booklet maker.8
Chapter 5 - Error Conditions, Problems and Solutions 105
Clear a Stitch Head Jam