User manual

Clear the Jammed Wire
#
InformationActionStep
A
Detail A: Cut stitch-wire here.
Cut the stitch-wire at position
'A' approximately 50mm (2-
inches) from where the stitch-
wire leaves the stitch-wire
guide.
1
B
Detail B: Cut stitch-wire here.
Cut the stitch-wire at position
'B' between the feed gears and
the middle wire tube.
2
Pull stitch-wire in direction of arrow
Pull the stitch-wire from the
stitch-wire guide block.
3
See ‘Introduction’ on page 100Remove the middle wire tube.4
Pull the wire from the stitch
head.
5
See ‘Install the Stitch-wire into the Stitch
Head’ on page 135
Install the stitch-wire into the
stitch head.
6
Chapter 5 - Error Conditions, Problems and Solutions 101
Clear a Stitch-wire Jam