User manual

83
Clear a Stitch Head Jam
[44]
Step Action Information
1 Lift the Booklet maker main
deck.
See Lift the Booklet maker Main Deck
on page 41
2 Remove the wire-holder
from the stitch head.
■ Move the wire-holder retaining
spring to the right. figure 42 on
page 81
■ Remove the wire-holder
If the wire-holder is held in position,
use a screwdriver to help remove the
wire-holder from the stitch head.
[44]
3 Inspect the area behind the
wire-holder for stitch-wire.
figure 43 on page 82
4 Remove any stitches or
pieces of stitch-wire and
clean the area with the air
duster.
Use wire cutters to remove any
jammed stitches or pieces of
stitch-wire.
5 Lubricate the stitch-head. Lubricate the Stitch Head on
page 102
6 Fit the wire-holder. Remember to put the wire-holder
retaining spring in position.
7 Close the Booklet maker.
8 Start the Booklet maker. If the head operates normally and
returns to the parked position, then
further action is not needed.
If the stitch-head remains jammed,
then repeat the procedure again.
If the problem continues, contact
your service engineer.