User manual

78 Chapter 5 Error Conditions, Problems, and Solutions
Clear a Stitch Wire Jam
[38]
Before You Begin
[39]
Clear the Jammed Wire
[40]
A Top location of Middle Wire Tube
BMiddle Wire Tube
CMetal Spring Clip
DFeed Gears
Step Action Information
1 Turn off the Booklet maker Use the ON/OFF switch.
2 Disconnect the Booklet maker
from the power supply.
3 Lift the Booklet maker main
deck
(see ‘Lift the Booklet maker Main
Deck’ on page 41)
Step Action Information
1 Cut the stitch wire at position
'A' approximately 50mm (2
inches) from where the stitch
wire leaves the stitch wire
guide.
[38]
Detail A: Cut stitch wire here.
2 Cut the stitch wire at position
'B' between the feed gears
and the middle wire tube.
[39]
Detail B: Cut stitch wire here.
3 Pull the stitch wire from the
stitch wire guide block.
[40]
Pull stitch wire in direction of arrow
A
B