User manual

76 Chapter 5 Error Conditions, Problems, and Solutions
Stitch Head Problems
Stitch Head Problems
[37]
Problem Cause Solution
The stitch head does not
operate
The STITCH function is
not selected.
Make sure STITCH is set
to 1 or more (see ‘The
BASIC Window’ on
page 25).
The stitch wire is
finished.
Load a new spool of
stitch-wire (see ‘Install
New Stitch Wire’ on
page 107).
The stitch wire is
jammed.
Clear the jammed stitch
wire (see ‘Clear a Stitch
Wire Jam’ on page 77).
The stitches are broken There is stitch wire
jammed in the stitch head.
Inspect and remove the
jammed stitch wire (see
‘Clear a Stitch Wire Jam’
on page 77).
The stitch wire is jammed
on the spool
The stitch wire spool is
not installed correctly.
Check and correct (see
‘Fit a New Stitch Wire
Spool’ on page 108).