User manual

72 Chapter 5 Error Conditions, Problems, and Solutions

Clear Paper Jams

Jam in the Stitch Area

[33]

Jam in the Folder or Former Area

1. Open the folder cover.

2. Remove the jammed paper. If you cannot see the paper in the former area. (see ‘Jam

in the Trim Area’ on page 74)

3. Close the folder cover.

4. If there is paper in the gathering area, touch START , then touch ADVANCED >

PURGE SET > PURGE SET to clear the set from the machine.

5. Continue the print job.

Jam before the Trimmer

The error message JAM BEFORE TRIMMER is displayed. This error can be

1. a book jammed before the trimmer

2. a piece of paper trimming has covered the jam sensor

Step Action Information

1 Open the folder cover. (see ‘Open and Close the Folder

Cover’ on page 37)

2 Lift the clincher frame. (see ‘Lift and Lower the Clincher

Frame’ on page 38).

3 Remove the jammed paper.

4 Check for broken or damaged

stitches in the clincher area.

Manually operate the clincher

to clear any stitches that are

jammed.

[35]

Press to manually operate the

clincher.

5 Lower the clincher frame. (see ‘Lift and Lower the Clincher

Frame’ on page 38)

6 Close the folder cover.

7 If there is paper in the

gathering area, touch START,

then touch ADVANCED >

PURGE SET > PURGE

SET.

This action clears paper from the

BLM 500 / Bookletmaker 50.

8 Continue the print job.