User manual

67
Book Quality
[28]
Incorrect - The spine needs more form.
Check these settings:
The SET THICKNESS
setting is incorrect
Measure the set thickness
and enter the correct
dimension. Enter the Job
Settings on page 14
The folder cover is not
securely closed?
Close the folder
cover.Close the Folder
Cover on page 37
The FORM function is
not turned on?
Turn on the FORM
function. See "FORM" in
table 9 on page 25
The THRESHOLD
value is less than the SET
THICKNESS?
Decrease the
THRESHOLD value.
See THRESHOLD
table 9 on page 25
Does the spine need more
form at one end?
Change NUMBER to 2
or 4. See "FORM" in
table 9 on page 25
Does the spine need more
form at each end?
Increase PRESSURE.
Then, if the spine still
needs more form,
increase NUMBER. See
"FORM" in table 9 on
page 25
[29]
Incorrect - The spine is damaged or there are
creases near the spine.
Check these settings:
The SET THICKNESS
setting is incorrect?
Measure the set thickness
and enter the correct
dimension. Enter the Job
Settings on page 14
The spine of the book
needs less forming.
Decrease PRESSURE.
Then, if the spine is still
over formed, decrease
NUMBER. See "FORM"
in table 9 on page 25
Spine Form Condition