User manual

87
Lubricate the Stitch Head
Before You Begin
[52]
Apply the Grease to the Driver Bar
[53]
Step Action Information
1. Trim the first part from the nozzle. figure 44 on page 85
2. Remove the cap from the tube of grease.
3. Fit the nozzle to the tube of grease.
4. On the user interface, touch
ADVANCED > STITCHER UP >
STITCHER UP
The folder cover must be
closed. This action moves the
stitch head to the correct
position for lubrication.
5. Lift the BLM500 main deck See Lift the Océ BLM500 Main
Deck on page 40
Step Action Information
1 Use the supplied air duster to
remove dust from the stitch head.
2 Remove the wire holder from the
stitch head.
Move the wire holder retaining spring
to the right. Then remove the wire
holderIntroduction on page 85
3 Apply a small amount of grease
to the visible surface of the driver
bar
figure 46 on page 86
[47]
[48]
4 Re-fit the wire holder.
30mm